Hi , does anyone know if the MTB U20 skewers work on road wheels ?
tune U20 MTB Skewers fit standard road wheels
Moderator: robbosmans
Xena a demi god among the digital demimonde that is WW community
http://i.imgur.com/hL5v3ai.jpg
https://www.flickr.com/photos/131970499@N02/
http://i.imgur.com/hL5v3ai.jpg
https://www.flickr.com/photos/131970499@N02/
Not directly answering your question but the Tune mtb TT skewers had just enough thread to work with the thin tabs on my thm fork and R5ca dropouts. I cut off about 3mm on each.
Sent from my SM-G930V using Tapatalk
Sent from my SM-G930V using Tapatalk
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com
Thanks Ryan.
Xena a demi god among the digital demimonde that is WW community
http://i.imgur.com/hL5v3ai.jpg
https://www.flickr.com/photos/131970499@N02/
http://i.imgur.com/hL5v3ai.jpg
https://www.flickr.com/photos/131970499@N02/
They're supposed to come with 2 sets of ends, some thin ones for 135 mtb, and thicker ones for 130 road.
The front has 2 sets as well. So which end set to use also depends on your dropout thickness.
The stock U20s are long enough for just about any frame.
BTW, if you trim the alloy threads down past a few mm, you risk exposing the carbon center.
But the threads are securely glued anyway. Best to leave the threads as is, and use the thicker ends.
The front has 2 sets as well. So which end set to use also depends on your dropout thickness.
The stock U20s are long enough for just about any frame.
BTW, if you trim the alloy threads down past a few mm, you risk exposing the carbon center.
But the threads are securely glued anyway. Best to leave the threads as is, and use the thicker ends.
UpFromOne wrote:They're supposed to come with 2 sets of ends, some thin ones for 135 mtb, and thicker ones for 130 road.
The front has 2 sets as well. So which end set to use also depends on your dropout thickness.
The stock U20s are long enough for just about any frame.
BTW, if you trim the alloy threads down past a few mm, you risk exposing the carbon center.
But the threads are securely glued anyway. Best to leave the threads as is, and use the thicker ends.
OK thanks but goal is to have lighter product as possible( so it is why i want to shorten rear one and use small end) and I can have very good price but only on mtb version
Visit starbike.com Online Retailer for HighEnd cycling components
Great Prices ✓ Broad Selection ✓ Worldwide Delivery ✓
www.starbike.com